Moparts Tech Archive

Big Block

BB Intakes Pic Album

If you have a pic of a BB intake thats not picutered here or a better then then the one we have. Then Then sent it along to one of the mods and we'll add it or up-date the one that here.
Thank you.
carl
*********************************************





Edelbrock TM-6 for 383/400, I think the part number is 2710 as that is cast in the bottom. Manifold height is Edelbrock method, straight edge on carb pad, measured at front and rear block rails (valley pan surfaces).
*************************************************

Edelbrock single plane Torker440 with EGR #3015

*************************************************


Eldelbrock STR14

*************************************************



*************************************************

Weiand Stealth Medium rise/dual plane #8008
Square flange fits 361, 383, 400

And also for the RB's:

Weiand Stealth low rise/dual plane #8009
Square flange fits 413, 426 wedge, 440

*************************************************


*************************************************

The long manifold is off late 50 early 60 big block

*************************************************

The dark blue one is a factory piece from a B engine 350! single plane - dual quad casting # 1827899-1 dated 10-57. heavy cast iron boat anchor! Pretty sure this is a Golden Comando bit.
*************************************************

Orange is an Offenhauser called a 360 degree. Single plane dual quad with both banks isolated from each other. casting # 5206. Carb mounting plates are replaceable to ease the use of various carbs. For RB engines.
************************************************

The TM-6 and Torker side by side.

The top of the Torker

Tech Index